StandardDev

SCPI Command :

FETCh:BLUetooth:MEASurement<Instance>:MEValuation:LIST:SEGMent<nr>:MODulation:SDEViation
class StandardDevCls[source]

StandardDev commands group definition. 2 total commands, 1 Subgroups, 1 group commands

class FetchStruct[source]

Response structure. Fields:

  • Reliability: int: ‘Reliability indicator’

  • Seg_Reliability: int: Reliability indicator for the segment. The meaning of the returned values is the same as for the common reliability indicator, see previous parameter.

  • Out_Of_Tol: float: Percentage of measured bursts with failed limit check

  • Nominal_Power: float: Standard deviation of average power during the carrier-on state

  • Freq_Acc_Or_Init_Freq_Error: float: Standard deviation of frequency accuracy (BR, LE) or initial center frequency error ωi (EDR)

  • Freq_Drift: float: Standard deviation of frequency drift (BR, LE)

  • Max_Drift_Rate: float: Standard deviation of maximal drift rate (BR, LE)

  • Delta_F_299_P: float: Standard deviation of frequency deviation value Δf2 above which 99.9% of all measured Δf2 values occur (BR, LE) .

  • Omegai_Omega_0: float: Standard deviation of overall uncompensated frequency error (EDR)

  • Omega_0_Max: float: Standard deviation of maximum compensated frequency error (EDR)

  • Rms_Devm: float: Standard deviation of RMS DEVM (EDR)

  • Peak_Devm: float: Standard deviation of peak DEVM (EDR)

  • P_99_Devm: float: Standard deviation of DEVM value below which 99% of all measured DEVM values occur (EDR) .

  • Freq_Offset: float: Standard deviation of frequency offset (LE)

  • Initial_Freq_Drift: float: Standard deviation of initial frequency drift (LE)

fetch(segment=Segment.Default) → FetchStruct[source]
# SCPI: FETCh:BLUetooth:MEASurement<Instance>:MEValuation:LIST:SEGMent<nr>:MODulation:SDEViation
value: FetchStruct = driver.bluetooth.measurement.multiEval.listPy.segment.modulation.standardDev.fetch(segment = repcap.Segment.Default)

Returns modulation single value results for segment<no> in list mode. The command returns all parameters listed below, independent of the selected list mode setup. However, only for some of the parameters measured values are available. For the other parameters, only an indicator is returned (e.g. NAV) .

param segment:

optional repeated capability selector. Default value: S1 (settable in the interface ‘Segment’)

return:

structure: for return value, see the help for FetchStruct structure arguments.

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.bluetooth.measurement.multiEval.listPy.segment.modulation.standardDev.clone()

Subgroups